POWER UNITS
Internal power units – 1 HP and 3.2 HP. External power units – 3 HP, 5 HP, 7 1/2 HP, up to 20 HP. Higher horsepower is available and determined during specific application solution design. Intermittent duty, continuous duty, wash down and stainless steel units are also available. Options to run multiple separately powered equipment at one time are also available.
(*Note: 12 VDC is 1.30 gpm @ full charge of the battery)
| HP | GPM @2000 PSI |
|---|---|
| 12 Volt * | 1.30 |
| 1.0 HP | 0.95 |
| 1.5 HP | 1.30 |
| 2.0 HP | 1.30 |
| 3.0 HP | 2.20 |
| 3.2 HP | 2.50 |
| 5.0 HP | 3.60 |
| 7.5 HP | 5.30 |
| 10.0 HP | 7.40 |
| 15.0 HP | 10.60 |
| 20.0 HP | 13.50 |
| 25.0 HP | 18.20 |
| 30.0 HP | 21.80 |
| 40.0 HP | 25.50 |
POWER UNIT VOLTAGE
110/220V/60 Hz single phase, 230/460V/60Hz 3 phase, 575V/3PH/50 Hz and 308V/3PH/50 Hz pump motor voltage on hydraulic power units available. All units are configured at 60hz. 50hz and other non-US standard options are available based on specific application design needs.
Internal Power Unit / Internal Mounted External
| Motor Duty | Power Unit Size | Line Voltage / Phase | Line Voltage / Phase | Line Voltage / Phase | Line Voltage / Phase |
|---|---|---|---|---|---|
| On-Off Duty | 1 HP | 110/220VAC 1 PH | 230VAC 3 PH | 460VAC 3PH | – |
| On-Off Duty | 3.2 HP | – | 230VAC 3 PH | 460VAC 3PH | – |
External Power Unit
| Motor Duty | Power Unit Size | Line Voltage / Phase | Line Voltage / Phase | Line Voltage / Phase | Line Voltage / Phase |
|---|---|---|---|---|---|
| On-Off Duty / Continuous Duty | 3 HP | – | 230VAC 3 PH | 460VAC 3PH | 575VAC 3PH |
| On-Off Duty / Continuous Duty | 5 HP | – | 230VAC 3 PH | 460VAC 3PH | 575VAC 3PH |
| On-Off Duty / Continuous Duty | 7.5 HP | – | 230VAC 3 PH | 460VAC 3PH | 575VAC 3PH |
| On-Off Duty / Continuous Duty | 10 HP | – | 230VAC 3 PH | 460VAC 3PH | 575VAC 3PH |
Manual Pump
Foot pedal operated manual pump option. No electricity needed.
HIGH CYCLE PACKAGES
High cycle packages may be required for applications exceeding 15 cycle per hour on internal power units and 20 cycles per hour on external power units, and are available based on specific application design requirements. High cycle packages can include re-grease-able pivot points (center pins and pivot pins), NFPA cylinders, common lubrication points (lube manifold), continuous running power units, a UHMW centering system and replaceable wear tracks.
